Top band DX-ing is real ham radio challenge. 160m is also referred as the "Gentleman's band"...
160 meters - DX-ing on the Edge...

Antennas inspiration - part III.

17. dubna 2008 v 21:47 |  Antennas

Double-L antenna 160/80m by K2KQ

Don Toman, K2KQ
A popular misconception about vertical antennas for the low bands is that they must have elaborate ground systems. Here's a vertical antenna for 80 and 160, fed with a single feed line that is simple, effective, and requires no ground system. You won't beat the 4-squares, but you will hold your own against a grounded quarter wave with ridiculous amounts of copper in the ground.
Rather than get into the theory of why this antenna works, I will simply describe it here and let results speak for themselves. If there's a demand, I'll do a follow-up article on the relevant theory.
The antenna is a center-fed half-wave vertical with about 70 feet of vertical length with the remainder of the top and bottom of the antenna bent horizontal and parallel to each other. The antenna looks like a squared-off letter "C" fed in the middle of the vertical part.
Thus, the 160-meter antenna is a 270-foot dipole fed in the center with the bottom antenna wire bent parallel to the ground about 10 feet off the ground and the top at 80 feet off the ground. The horizontal parts are 100 feet long and parallel to each other.
The 80-meter antenna is a 130-foot dipole, fed in the center with 70 feet vertical and 30 feet horizontal 10 feet off the ground and 80 feet off the ground.
Think of it as an inverted L fed against an L. The two Ls are balanced with respect to each other and because the currents in the horizontal sections are out of phase, the antenna has a minimum of horizontal radiation.
The 80 meter and 160 meter antennas are separate, fed from a common coaxial feed line.
In my case, the 80-meter and 160-meter horizontal sections are about 30 degrees apart. The 160 horizontal wires run east while the 80 wires run east-northeast.
On both bands, the bulk of the current flows symmetrically in the center of the antenna, with the current peak about 45 feet off the ground at the feed point. On 80, the current loop peak is about 0.16 wavelengths above ground and on 160, the current loop is about 0.08 wavelength above ground.
The accompanying figure illustrates the antenna.
You can adjust the resonance of the antenna by adjusting the lengths of lower horizontal sections. The small asymmetry doesn't bother anything. The center impedance of mine at resonance is very close to 50 ohms on 160 and close to 70 ohms on 80. The 160 antenna presents high impedance at 80 meters and the 80-meter antenna looks like a parallel capacitor across the 50-ohm 160 antenna. The 160 antenna covers 1800-1860 with under 2:1 SWR. I needed to take about 2 feet off the horizontal section to get mine resonant at 1830. If 80-meter current flows in the 160 antenna, it tends to flatten the current loop in the vertical section.
The 80 meter antenna is resonant at 3750 with the 130-foot length shown. The VSWR is under 2:1 over the DX part of the 'phone band. It needs to have some length added to cover the CW portion. I haven't tried to bring it to resonance in the CW band, but have chosen to feed it through a tuner.
I originally had this antenna hung from trees. This year I put up an 80-foot Rohn-25G with three sets of guys. I hung the wires from ropes attached to the tower so they are separated from it by about 3 feet. The coaxial feed line comes off perpendicular to the antenna and is then taped to the tower. The center conductor goes to the top and the shield goes to the lower part. Before the coax turns on to the tower, I've wrapped some 30 feet of it into a coil. I expected to see a lot of interaction, but the tower and guys seem well off resonance at the operating frequencies and I didn't see any to worry about.
The first QSO on 80 was VK6LK, long path on SSB at sunset on September 12. I've worked a few ZSs, HF0POL, LU, and the usual Europeans. On 160, the first QSO was KP4SN on September 15. In the couple of weeks since hanging it from the tower, I've worked ZS6UT, TU2MA, TL5A, VK6VZ, VK6LK, VK3ZL and NL7Z and the usual horde of Europeans on 160 with no fuss. I run about 800 watts out from a Ten-Tec Centurion.
Last January, I had about 200,000 points with 750 QSOs in the CQ WW CW 160 contest using the predecessor hung from trees.
73, Don K2KQ
Well with permission of Don, K2KQ I am sharing an article about this Double-L antenna usable for 160m band. Unfortunatelly its impossible to install this antenna for Topband on my garden as there is no way to errect 21m tall vertical section. Maybe some of shortenning of the vertical parts will make me chance to test it also.
I pretty sure that it can help to lot of Topbanders solve their antennas troubles on pocket size garden but with enough tall tree.
73, Petr OK1RP
...-.-
 

Buď první, kdo ohodnotí tento článek.

Komentáře

1 Mark, PA5MW Mark, PA5MW | E-mail | Web | 15. května 2008 v 10:39 | Reagovat

Hello Petr,

I'm looking for the ideal 160m TX antenna on a 'pocket lot-size'  too.

However this so called 0.5 wave bended vertical is not my favourite. I would rather install an inverted L with ground or elevated radials. Te most important parameter on short vertical is to make the vertical part as long as possible. This "vertical dipole" idea compromises that criteria. But every antenna is still better than no antenna :)

'73 Mark, PA5MW

http://pa5mw.blogspot.com

2 ERIC S58F ERIC S58F | E-mail | Web | 3. října 2008 v 20:44 | Reagovat

Hello Petr and all top band ¨gang¨(hi)

Today I decide to write here a few line's.

In the previous coment the Mark PA5MW are looking for ideal 160m TX antenna.

My story:

Since end of last 160m low band season (Feb.) was working with a 1/2 wl dipole at 16m AGL..so I decided to take the risk (hi) to build a Inverted L antenna (I nide low angle radiation)

On WEB I'm finde very nice scheme http://www.kn4lf.com/kn4lf3.htm for 160 METER BROAD BAND COAXIAL INVERTED L ANTENNA.

How this antenna work? The last test are indicate

the antenna work very very well - have nice low angle radiation!!

The vertical section of my antenna is 17m long (I use 18m spiderbeam fiberglass pole)then 22m horizontal..in this moment I have 20 1/4 wl radials + 10 1/8wl..

Have a lot of building fun

ERIC S58F

3 Giovanni Giovanni | E-mail | Web | 19. června 2012 v 15:25 | Reagovat

To jsem zvědav jak to dopadne...

Nový komentář

Přihlásit se
  Ještě nemáte vlastní web? Můžete si jej zdarma založit na Blog.cz.
 

Aktuální články

Reklama